Mobotix D16 DualDome Manual page 37

First Installation Steps
1. Remove the outer shell : Remove the outer shell using the supplied custom tool. Insert
the tip of the custom tool into the three small holes of the shell, one by one. Lift the
outer shell to loosen it from the fixtures.
2. Remove the dome : Pick up the dome using the supplied
plastic foil or a cotton cloth and remove it by turning
it counterclockwise.
3. Insert the sensor modules and mount the central
lens screw : Remove the center lock screw and the
washer. Insert the sensor modules into the seatings.
Insert the lock screw with a washer into the center of
the camera and gently tighten it to hold the sensor
modules in place.
Touch the mount of the sensor modules only. Always avoid direct contact with the
contacts on the green circuit board (ESD) in order to prevent damage arising now or
later and to avoid reducing the service life.
4. Remove the lens cover on the image sensors : Press
the two bars on the side of each lens cover (red arrow)
and remove the covers one after another in the direction
of the gray arrow.
Note
Use the supplied custom tool
Max. tightening torque of
the lock screw: 1 to 1.2 Nm
37