Connecting The Ethernet Cable With The Mx-Overvoltage-Protection-Box; Connecting The Miniusb Cable - Mobotix D16 DualDome Manual

First Installation Steps

2.3.3 Connecting the Ethernet Cable with the MX-Overvoltage-Protection-Box

The MX-Overvoltage-Protection-Box protects the MOBOTIX
camera against surges of up to 4 kV and provides for easy
attachment of network installation cables (-LSA variant) or
patch cables (-RJ45 variant):
Outdoor installation (preferably using the Outdoor Wall
•
Mount )
• Indoor installation with Ethernet installation cable
For more information on the MX-Overvoltage-Protection-Box,
please visit www.mobotix.com and go to the Products > System
Components > Interface Boxes and Sensors section.

2.3.4 Connecting the MiniUSB Cable

Existing additional modules like the MOBOTIX ExtIO (USB) can be connected via the MiniUSB
connector.
1. Remove the outer shell : Remove the outer shell using
the supplied custom tool. Insert the tip of the custom
tool into the three small holes of the shell, one by one.
Lift the outer shell to loosen it from the fixtures.
2. Remove cable cover : Remove the two M4x25 Allen
screws from the cable cover using the 3-mm Allen
wrench.
3. Remove cable cover : Remove the two M4x25 Allen
screws from the cable cover using the 3-mm Allen
wrench.
4. Remove rubber plug : Carefully bend the cable guide
upwards and remove the rubber plug. Keep the rubber
plug in a safe place (ideally in the camera's original
packaging).
Use the supplied custom tool
41