Mobotix D16 DualDome Manual page 38

D16 Camera Manual: Installation
RGB SW
38
5. Connect the sensor cable to the lens mount : Connect the R and L sensor cables
with the image sensors in accordance with the table. Example : In the case of a
D16-DNight (color/black and white), the R sensor cable must always be connected
to the lens mount marked with RGB, while the L sensor cable must always be con-
nected to the lens mount marked SW.
Never pull the sensor cable forcefully! To remove it, first disconnect the plug by press-
ing lightly on the notch (1) and then carefully pull it upwards
(2).
Always avoid direct contact with the contacts on the green
circuit board (ESD) in order to prevent damage arising now
or later and to avoid reducing the service life.
6. Insert the sensor cable : Insert the sensor cable through
the space in the circuit board. Make sure that the indi-
vidual wires are gently curved and are not bent near
the plug.
7. Place the lens cover on the image sensors : Carefully
push the lens covers one after another in the direction
of the gray arrow onto the plug until they click into
place.
8. Align the image sensors and cable guide: Align the
image sensors so that the plugs of the sensor cable
point towards the interior of the dome (see red marking
in the figure). This will ensure the images appear in the
correct position later on and not upside down. Make
sure that the sensor cable is as straight as possible and
fix the cable in place using the corresponding guides.
Note
1
2