Start Options Of The Camera - Mobotix D16 DualDome Manual

D16 Camera Manual: Operating the Camera
1
4 2
3
LED Default Settings:
1 Power (on),
Error (flashing)
2 Recording (flashing)
LED
flashes
1 x
2 x
3 x
4 x
*Only on cameras with audio option and installed speaker.
72

3.2.4 Start Options of the Camera

By default, the camera starts as DHCP client and automatically tries to get an IP address
from a DHCP server. To start the camera in a mode different from the default mode, you can
activate the boot menu of the camera.
Preparing the Camera
• Disconnect the camera's power supply.
• Make sure that you have the custom tool with magnet (item 1.8) at hand.
• Reconnect the power supply of the camera.
Activating the Boot Menu
The red LED lights up 5 to 10 seconds after establishing the power supply and will stay on
for 10 seconds. Briefly press the magnet of the custom tool onto the spot indicated by the
red circle in the figure. The camera enters the boot menu, ready for selecting one of the
boot options.
The LED now flashes once and repeats the flash signal after pausing for one second (the
number of flashes indicates the current boot option). To go to the next boot option, briefly
press the magnet again onto the designated spot (< 1 sec). After the last boot option, the
camera returns to the first option (LED flashes once).
Start Option Meaning
— This option is not used on this camera model.
Starts the camera with factory defaults (factory default IP address,
Factory Defaults
users and passwords will not be reset).
Starts the camera as DHCP client and tries to obtain an IP address
Automatic IP from a DHCP server. If a DHCP server cannot be found or no IP
Address address can be obtained, the camera starts with its factory default
address.
Starts the camera with the recovery system, e.g., in order to recover
Recovery System
from a failed update of the camera software.
Selecting a Start option
Press the magnet longer (> 2 sec) onto the indicated position. The camera confirms the
selection by flashing rapidly three times. You can now remove the magnet. After 20 sec, the
camera will confirm the selection by playing a sound according to the table above.
If nothing is selected, the camera will resume its normal boot process after a certain time.
Audio
Confirmation*
—
Boing
Boing Boing
Alarm Sound