Mobotix D16 DualDome Manual page 48

D16 Camera Manual: Installation
The folded drilling tem-
plates can be found at
the end of the manual
Make sure that the drilling
template is not scaled
down when printing
Silicon for rough plaster
48
Use the supplied drilling template (fold-out at the end of this manual) to mark the position
for drilling the anchor holes and the holes through which the cables will be led later on.
Make sure that it is not scaled down when printing or copying the drilling template.
1. Use the supplied screw anchors (10 mm), screws
(8x70 mm) and washers (diam. 9 mm) to secure the
Outdoor Wall Mount.
2. Attach the supplied wall sealing to the rear side of the
wall mount. If the Outdoor Wall Mount is mounted to
a very rough surface, the top of it should be subse-
quently sealed against the wall using silicon.
3. The rectangular opening on the rear of the wall mount
is intended to cover the installed in-wall socket or a
MOBOTIX interface box.