Sensor Module Cabinet Smc40; Communication Board Cbc10 For Canopen - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
3.1 Diagnostics via LEDs
3.1.3.4

Sensor Module Cabinet SMC40

Table 3- 36 Meaning of the LEDs on the Sensor Module Cabinet-Mounted SMC40
LED Color
RDY –
READY
Green
Orange
Red
Green/red Flashing light
Green/
orange
or
Red/
orange
Each channel has a multifunction LED.
3.1.3.5

Communication Board CBC10 for CANopen

Table 3- 37 Meaning of the LEDs on the Communication Board CAN CBC10
LED Color
OPT –
on the
Control
Unit
Green
Red
264
Status Description, cause
Off Electronics power supply is missing or outside the
permissible tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-
light CLiQ communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
light
Continuous At least one fault is present in this component.
light
Note:
LED is controlled irrespective of the corresponding
messages being reconfigured.
Firmware download is complete. Waiting for POWER ON.
2 Hz
Flashing light Component recognition via LED is activated (p0144).
Note:
Both options depend on the LED status when module
recognition is activated via p0144 = 1.
State Description, cause
Off Electronic power supply is missing or outside permissible
tolerance range.
Communication Board either defective or not inserted.
LED ON OPERATIONAL
LED PREOPERATIONAL
Blinking
No PDO communication possible
LED STOPPED
Single
Only NMT communication possible
flash
LED ON BUS OFF
LED ERROR PASSIVE MODE
Single
The error counter for "error passive" has reached the value
flash
127. After the SINAMICS drive system was booted no
further active CAN component was on the bus.
LED Error Control Event, a Guard Event has occurred
Double
flash
Commissioning Manual, (IH1), 01/2013, 6SL3097-4AF00-0BP3
Remedy
–
–
–
Remedy and
acknowledge fault
Carry out a POWER
ON
–
Remedy
–
–
–
–
Check baud rate
Check cabling
Check baud rate
Check cabling
Check connection to
CANopen master
Commissioning Manual