Misuse; Personnel Qualification; Specialist Personnel For Operation; Specialist Personnel For Maintenance - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

2 .3

Misuse

Use other than as stated in the section entitled
"à "Intended use" on page 7" is misuse. The
operator of the AT2000 CPK bears sole responsibility
for injury and damage resulting from misuse.
The following are specifically prohibited:
• Use with faulty parts
• Use in explosive environments or in the presence of
a fire hazard
• Use in high humidity and/or direct sunlight
• Simultaneous use by two or more persons
• Unauthorised alterations and modifications to the
AT2000 CPK and its accessories without the prior
consent of HellermannTyton
• Use of spare parts and accessories not tested and
approved beforehand by HellermannTyton
• Operation of the AT2000 CPK with the housing open
2 .4

Personnel qualification

Underage persons and trainees are permitted to use the
device only under the supervision of an experienced
specialist and only with the express permission of the
operating company.

2 .4 .1 Specialist personnel for operation

The tasks and authorisations assigned to specialist
personnel for extended operation are as follows:
• Operating the AT2000 CPK
• Rectification of faults or, as applicable, initiation of
measures for the rectification of faults
• Cleaning the AT2000 CPK
These individuals have the specialist training or practical
experience that will ensure correct handling.
2 .4 .2 Specialist personnel for maintenance and
servicing
Always have maintenance and servicing carried out by
duly qualified specialist personnel. These individuals have
the specialist training that affords sufficient knowledge
of the AT2000 CPK for them to judge when it is in safe
working order.
These individuals are also familiar with the following
rules and regulations:
• Applicable national health and safety regulations
• Accident prevention regulations
• Generally accepted rules of engineering practice (e.g.
employers' liability insurance association codes, DIN
standards, VDE regulations, technical rules of other
European Union Member States or other signatories of
the Agreement on the European Economic Area).
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004

2 .4 .3 Qualified electrician

Work on the electrical supply and on parts that are live
when the device is in operation should always be carried
out by a trained electrician.

2 .4 .4 Authorised specialist for repair and testing

Only service technicians from HellermannTyton or service
technicians certified by HellermannTyton are permitted
to carry out repairs and safety checks.
a .1 Underlying hazards associated with use of the
AT2000 CPK

2 .4 .5 Cleanliness at the workplace

Orderliness, good lighting and cleanliness at the
workplace all help to make work easier, minimise
hazards and reduce the risk of injury.
Always comply with the following principles of
orderliness and cleanliness at the workplace:
f Put tools away as soon as they are no longer needed.
f Avoid trips (e.g. immediately dispose of waste by placing
it in the containers provided for the purpose).
f Immediately remove spillages of grease, oil and other
liquids.
f Clean smears off the controls.

2 .4 .6 Spare parts and accessories

f Use only original replacement parts.
f After parts have been replaced, always check that
everything is in full working order.
f Use only accessories approved by HellermannTyton.
Accessories can affect the way in which the AT2000 CPK
works.
Safety warnings
8