Accessing The Settings; Accessing The Parameter Set; Setting The Force Level; Setting The Binding Quality - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

f Use the Select button
2
the display menu.
f Press the Enter button
1
f Press the Enter button
1
start screen.
f Check the LED status indicator
on page 29.
A printed short guide is included with the AT2000 CPK which
schematically explains how to configure the functions.
7 .1

Accessing the settings

Settings
Access code
f Press the Select button
2
; The access code settings are displayed, à "Settings
menu" on page 15.
; Access to the Settings menu is protected by a three-digit
access code that can be changed in the HT Data
Management software, à "Changing the access code in
the AT2000 CPK" on page 20.
The default access code is 000.
When configuring settings in the display menu, the start
screen will be displayed after 10 seconds of inactivity.
7 .2

Accessing the parameter set

The preset parameter sets can be accessed or transferred
to the AT2000 CPK when the HTDM is connected. The
parameter sets comprise settings which are gathered
into groups. They are managed in the HTDM,
à "Parameter set menu" on page 17.
AT 2000 CPK
001
f Access the settings, à "Accessing the settings" on
page 13.
f Press the Select button
2
f The parameter set is indicated with a blue border.
3
f Press the Enter button
1
is displayed.
3
; The settings of the selected parameter set are displayed.
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
to select the desired setting in
.
several times to return to the
, à "Troubleshooting"
3
0 0 0
.
.
until the desired parameter set
7 .3

Setting the force level

The setting corresponds to the force applied by the
AT2000 CPK when binding, and it can be set from
Level 1 (lowest force) to Level 5 (highest force).
3
1
f Press the Select button
2
f The force level
3
f Press the Enter button
reached.
; The force level
3
arrows.
7 .4

Setting the binding quality

The setting corresponds to the quality of binding and it
can be set from Level 1 (lowest quality) to Level 3
(highest quality). The higher the level the longer the
cycle time, so the bundle has more time to settle.
3
f Press the Select button
f The binding quality
f Press the Enter button
1
is reached.
; The binding quality
2
stars.
; The binding speed is indicated by the "speedometer
needle" position.
3
Settings in the display menu
AT 2000 CPK
001
.
2
is indicated with a blue border.
until the desired force level is
1
is indicated by the number of red
AT 2000 CPK
001
.
2
is indicated with a blue border.
3
until the desired binding quality
1
is indicated by the number of red
3
1
2
1
2
13