Positioning And Binding Items For Bundling; Emptying The Waste Box; Settings In The Display Menu - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

6 .4

Positioning and binding items for bundling

f Select the
Force level and/or
à "Accessing the parameter set" on page 13 or
à "Select parameter set" on page 19.
f Check the time and date; set if necessary,à "Date /
time" on page 16.
The device is suitable for the following bundle
geometries:
3
20 mm
2
42 mm
The distance from front cap
42 mm. Bundle can be no more than 20 mm in
3
diameter.
CAUTION
Crush hazard when jaws close .
f Do not insert fingers between upper and lower jaws and
do not keep your finger on the trigger.
f Always keep the power pack switched OFF when
clearing a blockage.
1
3
f Centre the bundle
in line with front-cap screws
1
Space adjacent cable ties at least 10 mm apart.
f Press the trigger
.
2
; The bundle is secured by the cable tie.
1
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
Quality parameters,
1
to flat must be at least
1 2
.
3

6 .4 .1 Emptying the waste box

The waste box has to be emptied after a maximum of
120 bindings at a bundle diameter of 3 mm. As the
bundle diameter increases, so does the number of
bindings until the waste box has to be emptied.
1
f Pull waste box
1
and empty the box.
f Close the waste box
7

Settings in the display menu

After switching on the AT2000 CPK at the connected
power pack, the start screen appears on the display.
The additional device functions (e.g. clock time) are
configured on the main menu, à "Settings in the main
menu" on page 15.
2
1 Enter button to confirm a selection in the navigation menu and increment switch
for display menu settings
2 Select and reset button for AT2000 CPK settings in the display menu
3 LED status indicator Signal:
Green: AT2000 CPK connected and ready
Red: Error
The functions for setting the bindings with the AT2000 CPK
can be directly accessed and configured in the display menu.
These include:
• Parameter set
• Force level
• Binding quality
• Loop diameter
• Cutting mode
• Cut with the tension released
Settings in the display menu
in the direction indicated by the arrow
.
1
AT 2000 CPK
001
1
2
3
12