Performing A Reset; Display Messages - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

10 .2 Performing a reset

A reset of the AT2000 CPK always has to be performed
before repair work is undertaken.
1
f Switch on the AT2000 CPK.

10 .3 Display messages

DISPLAY MESSAGE
Error, front cap
Remove cable-tie residues
Error, gate
Close gate
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
2
3
4
POSSIBLE CAUSE
• There are residues of cable
ties trapped behind the front
cap.
• The level sensor is busy.
• Drum is not in the correct
position.
• The gate is open.
f Push the actuator for bandoleer cutter
f Press the catch
.
3
f Open the gate
.
1
f Remove cable-tie residues where necessary.
f Press the reset button
4
f Close the gate
.
1
SOLUTION
f Clean the front sensor.
f If applicable, carefully remove the cable-tie residues.
f Open the gate and turn the drum to the correct
position.
f Close the gate.
Troubleshooting
to the left.
2
.
30