Synchronising Time And Date; Display Binding Information; Select Parameter Set; Set Interruption Front Sensor - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

9 .3 .3 Synchronising time and date

f Click on
Synchronise with PC time
; Clock time and date of the power pack are synchronised
with the PC connected to the device.
Time and date are saved in the power pack and have to be
rechecked if the power pack is subsequently replaced.

9 .3 .4 Display binding information

Binding information shows the process data of the
7
last binding performed with the connected AT2000 CPK.

9 .3 .5 Select parameter set

In the parameter sets, preset values are grouped and
transferred to the AT2000 CPK, à "Parameter set
menu" on page 27
f Select a configured parameter set in the
field.
8
; The changed parameters are transferred to the AT2000
CPK.

9 .3 .6 Set interruption front sensor

The Interruption front sensor
decide how long the level sensor can remain busy
without the Error, front cap
display, à "Display messages" on page 30.
f Select the level in the Interruption front sensor
; There are five levels:
• Level 1: 0.0 seconds
• Level 2: 0.3 seconds
• Level 3: 0.5 seconds
• Level 4: 0.7 seconds
• Level 5: 0.9 seconds
; The setting is changed and transferred to the AT2000
CPK.

9 .3 .7 Setting the binding check

The Check of binding setting
whether or not the Error, binding force
appears on the display, à "Display messages" on
page 30
f Set the binding in the Check of binding
à "Check of binding" on page 16. The following
options are available:
• OFF
• Error notification
• Acknowledgement
; The setting is changed and transferred to the AT2000
CPK.
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
.
5
Parameter set
setting enables you to
9
message appearing on the
field.
9
enables you to decide
10
message
field,
10

9 .3 .8 Activating consecutive trigger

Consecutive trigger effects continuous binding
11
without repeatedly actuating the start trigger. Bindings
will be carried out as long as the start trigger remains
pressed.
f Activate the consecutive trigger

9 .3 .9 Status indicators

The Tool Status field displays the operating status of
12
the AT2000 CPK.
Colour
Connection to the Green
power pack CPK
Red
Grey
Connection to Green
AT2000 CPK
Red
Grey
Status of the Green
AT2000 CPK
Yellow
Blue
Red
Grey
HT Data Management
.
11
Status
Connection active
Error message active
No connection / connection
interrupted
Connection active
Error message active
No connection / connection
interrupted
Ready
Busy
Main menu on AT2000 CPK active
Binding not possible
Error message active
No connection / connection
interrupted
19