Measurement Environment Menu; Using Measurement Mode - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

9 .7

Measurement environment menu

The Measurement environment
user has logged on with the setup specialist's password.
4
1 Display binding information
2 Show binding parameter settings
3 Adjust the measured force
4 Manage measurement results
5 List of measurement results
6 Set the measurement mode
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
menu appears only if the
1
3
5

9 .7 .1 Using measurement mode

In measurement mode, the binding information for a
binding cycle with a measured force is documented in a
log file. This file can be used to monitor the AT2000 CPK.
In the measurement environment, the force measure-
ment device (106-29010 / 106-29011) and a suitable
force gauge can be used to carry out a measurement.
You can find more detailed information on using the force
measurement device in the corresponding manual.
No cycle movement or jaw movement takes place while
measurement mode is active. Only the tensioning drive is
active, with the current binding parameter settings.
f Select parameter set
2
; The corresponding force level and quality are displayed.
f Click on
Activate measurement mode
; The measurement mode functions are activated.
HT Data Management
2
6
.
.
6
25