Checking Front Cap And Position Of; Cutter; Checking Tie Advancer; Replacing Tie Advancer - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

11 .5 .3 Checking front cap and position of cutter
f Switch the power pack OFF.
1
4
f Remove the screws .
3
f Loosen the screws .
1
CAUTION
Cut hazard. The cutter is extremely sharp.
f Never touch the cutting edge with your fingers.
f Carefully remove front cap
f Remove the tail cutter
2
f If necessary, replace tail cutter
f Remove cable-tie residues.
f Use compressed air to blow the tension gear and the
waste channel clean.
f Insert the tail cutter
into the recess with the cutting
2
edge facing in.
f Insert front cap
with the lower jaw.
5
f Tighten the screws .
1
f Insert the screws and tighten.
3

11 .5 .4 Checking tie advancer

f Switch the power pack OFF.
1
f Push the actuator for bandoleer cutter
f Press the catch .
3
f Open the gate
.
1
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
2
3
with the lower jaw.
4
.
.
2
to the left.
2

11 .5 .5 Replacing tie advancer

f Remove the screw
f Swing roller block
f Replace the defective tie advancer
; The teeth of the tie advancer face down.
The tie advancer can be inserted in both directions.
2
3
f Push in the tie advancer as far as mark
A Position of tie advancer message appears
if positioning is not correct, à "Display messages" on
page 30.
f Close the roller block
f Tighten the screw
f Close the gate
.
1
Maintenance
.
4
up.
5
.
6
1
.
6
.
5
.
4
4
5
6
4
5
6
36