HellermannTyton Autotool 2000 CPK Operating Instructions Manual page 31

DISPLAY MESSAGE
Error, start position
1. Operate bandoleer cutter
2. Open gate
Error, start position
1. Remove cable-tie residues
2. Press Reset button
Error, start position
Close gate
Position of tie advancer
1. Operate bandoleer cutter
2. Open gate
Position of tie advancer
1. Press Reset button
2. Check position of tie advancer
Position of tie advancer
Close gate
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
POSSIBLE CAUSE
• The AT2000 CPK is not in
the start position.
• No tie advancer present.
• The tie advancer is faulty.
SOLUTION
f Push actuator for bandoleer cutter to the left.
f Open the gate.
; Error, start position appears as the next
message on the display.
f If applicable, carefully remove the cable-tie residues.
f Press the Reset button.
; Error, start position appears as the next
message on the display.
f Close the gate.
f Push actuator for bandoleer cutter to the left.
f Open the gate.
; Position of tie advancer appears as the
next message on the display.
f If applicable, carefully remove the cable-tie residues.
f Press the Reset button.
f Open the roller block, à "Checking tie advancer" on
page 36.
f Check the tie advancer; replace if necessary.
; Position of tie advancer appears as the
next message on the display.
f Close the gate.
Troubleshooting
31