Setting The Loop Diameter; Setting The Cutting Mode; Setting Tension-Free Cutting - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

7 .5

Setting the loop diameter

The actual diameter may deviate from the set value as
the gearing and the state of the tool and processing
material have an impact on the binding.
Make sure that the binding does not produce a circular loop.
AT 2000 CPK
3
0.1
001
f Press the Select button
2
; The loop diameter is indicated with a blue border.
3
f Press the Enter button
1
; The loop diameter value is activated.
f Press the Select button
2
; The adjustable value is underlined.
f Press the Enter button
1
value is displayed.
f Press the Select button
2
; The selection jumps forward one digit.
f Repeat the setting until the desired values is reached.
7 .6

Setting the cutting mode

AT 2000 CPK
3
001
Flush cutting
f Press the Select button
2
; The strip section is indicated with a blue border.
3
f Press the Enter button
1
; No strip section is displayed when flush cutting is
activated.
Cut-free binding
f Press the Enter button
1
; The projecting cable-tie end is indicated with a blue
border.
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
.
.
.
several times until the desired
.
.
to activate flush cutting.
to deactivate flush cutting.
Projecting cable-tie ends
The actual projecting cable-tie end may deviate from the
set value as the gearing and the state of the tool and
processing material have an impact on the binding.
1
3
2
f Press the Select button
f Press the Enter button
tie end value.
; The adjustable value
f Press the Enter button
value is displayed.
f Press the Select button
; The selection jumps forward one digit.
f Repeat the setting until the desired values is reached.
7 .7

Setting tension-free cutting

1
2
f Press the Select button
; Tension-free cutting
f Press the Enter button
; Tension-free cutting is indicated with a crossed-out
tension spring.
f Press the Enter button
cutting.
f Press the Select button
settings.
Settings in the display menu
AT 2000 CPK
3.1
001
.
2
to activate the projecting cable-
1
is underlined.
3
several times until the desired
1
.
2
AT 2000 CPK
001
.
2
is indicated with a blue border.
3
.
1
to deactivate tension-free
1
to finish configuring the
2
1
2
1
2
3
14