Settings In The Main Menu; Languages Menu; Status Menu; Settings Menu - HellermannTyton Autotool 2000 CPK Operating Instructions Manual

8

Settings in the main menu

After switching on the AT2000 CPK at the connected
power pack, the start screen appears on the display.
AT 2000 CPK
001
1 Enter button to confirm a selection in the navigation menu and increment switch
for display menu settings
The main menu in the AT2000 CPK enables the
configuration of additional device functions.
The menu covers:
• Languages settings in the display, à "Languages menu"
on page 15
• Device status, e.g. counter reading of the bindings or
firmware version, à "Status menu" on page 15
• Settings, e.g. date / time, à "Settings menu" on
page 15
• Contact, à "Contact menu" on page 16
Bindings cannot be triggered while you are navigating in the
main menu. The Signal LED on the power pack shows blue.
f Press the Enter button
1
; The Main menu appears on the display.
8 .1

Languages menu

You use the Languages menu to select the language for
the displays.
Languages
English
Deutsch
Français
Español
Portuguese
Italiano
Dutch
f Use the Select button
2
f Press the Enter button
1
; The display switches to the language you selected.
; The Main menu appears on the display.
Operating Instructions • AT2000 CPK • 07-2019 • v03 • 106-29004
.
to select the language.
.
8 .2

Status menu

Status
Counter reading
Tool software
1
Power-pack SW
Serial number
Temperature
Humidity
Last service
Cntr.rdng.lastSer
The Status menu shows you the following status readings:
• Counter reading
• Software version of the AT2000 CPK and an index
number for the language version
• Software version of the power pack
• Serial number of the tool
• Ambient temperature and humidity
• Date of last service
• Counter reading at last service
f Press the Enter button
; The Main menu appears on the display.
8 .3

Settings menu

You use the Settings
of the AT2000 CPK.
Access to the Settings
access code that can be changed in the HT Data
Management software, à "Changing the access code in the
AT2000 CPK" on page 20. The default access code is 000.
f Use the Select button
Settings menu.
f Press the Enter button.
; The prompt for the access code appears on the display.
1
Settings
2
Access code
f Press the Select button
f After reaching the desired number, press the Enter
button .
1
; The selection jumps forward one digit.
f Repeat the setting until the desired access code is set.
f Press the Enter button
; The Settings menu appears on the display.
Settings in the main menu
00000005
1.70/ 8/ 3
01:11
00000013
28
58
06/02/2019
0000000
.
1
menu to set important parameters
menu is protected by a three-digit
to select the
in the Main menu
0 0 0
.
2
.
1
1
2
1
2
15