Rod Electrode Setup Menu: Level 2; Opening The Rod Electrode Set-Up Menu Level 2; Changing Welding Parameters; Exiting The Rod Electrode Set-Up Menu - Level 2 - Fronius TransTig 2200 Operating Instructions Manual

Rod electrode setup menu: level 2

Opening the rod
electrode set-up
menu level 2
Changing weld-
ing parameters
Exiting the rod
electrode set-up
menu - level 2
Welding parame-
ELn
ters in the rod
Electrode line - characteristic selection
electrode setup
menu - level 2
Unit
Setting range
Factory setting
Open the rod electrode set-up menu
1
Select "2nd" welding parameter
2
Press and hold the "Mode" button
2
Press the right parameter selection button
3
The power source is now in the rod electrode set-up menu - level 2. The
last welding parameter selected is displayed.
Use the left or right parameter selection button to select the welding pa-
1
rameter that you want to change
Use the adjusting dial to change the welding parameter value
2
Press the Mode button
1
The power source is now in the rod electrode set-up menu
To exit from the Rod electrode set-up menu, press the Mode button again
2
1
con or 0.1 - 20 or P
con
85