Fronius TransTig 2200 Operating Instructions Manual page 30

No. Function
(4)
(5)
(6)
(7)
(8)
30
Welding voltage indicator
lights up when parameter I
is selected. During welding the current actual value for the welding voltage is
shown on the right-hand digital display.
Before welding, the following appears on the right digital display:
- 0.0 if a TIG welding mode is selected
- 50 V if an MMA welding mode is selected (after a delay of 3 seconds; 50 V is
approximately the average value for the pulsed open circuit voltage)
Unit indicators
A indicator
% indicator
lights up when the I
HCU setup parameters have been selected
s indicator
lights up when the t
up parameters have been selected:
- GPr
- G-L
- G-H
- UPS
mm indicator
lights up when the Fdb setup parameter has been selected
Process button
for selecting the welding process depending on the mode that has been chosen
2-step mode/4-step mode:
automatic cap-shaping;
only available in conjunction with TIG AC welding process
TIG AC welding process
TIG DC- welding process
Manual metal arc welding mode:
MMA AC welding process
MMA DC- welding process
MMA DC+ welding process
When a welding process is selected, the LED on the relevant symbol lights up.
Mode button
for selecting the mode
2-step mode
4-step mode
MMA welding
Right parameter selection button
for selecting welding parameters within the welding parameters overview (11)
When a welding parameter is selected, the LED on the relevant parameter symbol
lights up.
1
, I and I welding parameters and the dcY, I-G and
S 2 E
and t welding parameters plus the following set-
up down
- tAC
- Hti
- HFt