Fronius TransTig 2200 Operating Instructions Manual page 52

52
7
7
Insert the hexagon nut (size 50 mm)
5
into the holding plate
NOTE!
To ensure a reliable earth connection to
the housing of the power source, the
points on the hexagon nut must be fa-
cing the holding plate.
Screw the front of the large strain-relief
6
device into the hexagon nut (size 50
mm). The hexagon nut (size 50 mm)
now bites into the holding plate.
Slot the large strain-relief device into
7
the housing and fasten it with 2 screws
Connect the mains cable
8
Re-fit the left side panel of the power
9
source