Rod Electrode Setup Menu; Open The Rod Electrode Set-Up Menu; Changing Welding Parameters; Exiting The Set-Up Menu - Fronius TransTig 2200 Operating Instructions Manual

Rod electrode setup menu

Open the rod
electrode set-up
menu
Changing weld-
ing parameters
Exiting the set-up
menu
Welding parame- "Minimum" and "maximum" are used for setting ranges that differ according to power
ters in the rod source, wire-feed unit, welding program, etc.
electrode set-up
menu
HCU
HotStart current
Unit
Setting range
Factory setting
Hti
Hot-current time
Unit
Setting range
Factory setting
To obtain optimum welding results, it will sometimes be necessary to adjust the hotstart
function.
Benefits:
-
-
-
Press the Mode button to select the MMA welding mode
1
Press and hold the "Mode" button
2
Press the right parameter selection button
3
The power source is now in the rod electrode set-up menu. The last weld-
ing parameter selected is displayed.
Use the left or right parameter selection button to select the welding pa-
1
rameter that you want to change
Use the adjusting dial to change the welding parameter value
2
Press the Mode button
1
% (of main current I
0 - 200
150
s
0 - 2,0
0,5
Improved ignition, even when using electrodes with poor ignition properties
Better fusion of the base material in the start-up phase, meaning fewer cold-shut de-
fects
Largely prevents slag inclusions
)
1
83