Fronius TransTig 2200 Operating Instructions Manual page 35

No. Function
(9) Welding parameters overview
The welding parameters overview contains the most important welding parameters
to be used when welding. The sequence of welding parameters follows a clothes-
line structure. Use the left and right welding parameter selection buttons to navigate
within the welding parameters overview.
Welding parameters overview
The welding parameters overview contains the following welding parameters:
Starting current I
for TIG welding
The starting current I
"TIG DC- welding" modes.
Main current I
- for TIG welding
- for MMA welding
DownSlope t
when TIG welding, the period over which the current is decreased from the
specified main current I
The DownSlope t
Final current I
for TIG welding
(10) Adjusting dial
for altering welding parameters. If the indicator on the adjusting dial lights up, then
the selected welding parameter can be altered.
(11) Welding current indicator
for indicating the welding current for the welding parameters
- Starting current I
- Welding current I
- Final current I
E
Before welding commences, the left-hand digital display shows the set value. For
I and I , the right-hand digital display also shows the respective percentage of the
S E
welding current I .
1
After welding begins, the welding parameter I
hand digital display shows the actual welding current value.
In the welding parameters overview (9), LEDs for the various parameters (I
etc.) light up to show the relevant position in the welding process.
s
is saved separately for the "TIG AC welding" and
S
(welding current)
1
down
to the final current I
1
is saved separately for 2-step and 4-step modes.
down
E
S
1
1
E
is automatically selected. The left-
, I ,
S 1
35