Fronius TransTig 2200 Operating Instructions Manual page 32

No. Function
(12) Welding current indicator
(13) Left parameter selection button
(14) HF (high frequency) ignition indicator
(15) Overtemperature indicator
(16) Keylock switch (option for MW 2500 / 3000 / 4000 / 5000)
32
for indicating the welding current for the welding parameters
- Starting current I
S
- Welding current I
1
- Final current I
E
Before welding commences, the left-hand digital display shows the set value. For
I and I , the right-hand digital display also shows the respective percentage of the
S E
welding current I .
1
After welding begins, the welding parameter I
hand digital display shows the actual welding current value.
In the welding parameters overview (10), LEDs for the various parameters (I
etc.) light up to show the relevant position in the welding process.
for selecting welding parameters within the welding parameters overview (10)
When a welding parameter is selected, the LED on the relevant parameter symbol
lights up.
lights up when the HFt setup parameter has been set to an interval for the high fre-
quency pulses
lights up if the power source overheats (e.g. because the duty cycle has been ex-
ceeded). See the "Troubleshooting" section for more information.
When the key is in the horizontal position, all parameters and functions are disabled
with the exception of the currently selected parameter or function.
(16)
Keylock switch position
IMPORTANT! The functions available on the control panel of system components
are restricted in the same way as those on the control panel of the power source.
is automatically selected. The left-
1
, t ,
S 1