Alarm Center - HIKVISION AX DS-PW32-H Series User Manual

Alarm Center

You can set the alarm center's parameters and all alarms will be sent to the
configured alarm center.
Steps
1. Click Communication Parameters → Alarm Receiving Center to enter the Alarm
Receiving Center page.
2. Select the Alarm Receiver Center as 1 or 2 for configuration , and slide the slider
to enable the selected alarm receiver center.
Note
You can enable the backup channel when the Alarm Receiver Center is selected
as 2.
3. Select the Protocol Type as ADM-CID, EHome, SIA-DCS, *SIA-DCS, or *ADM-CID
to set uploading mode.
ADM-CID or SIA-DCS
-
You should select the Alarm Receiver Type as IP or Domain name, and enter
the IP/domain name, port number, account code, timeout, re-upload times
and heartbeat interval.
Note
Set the heartbeat interval with the range from 10 to 3888000 seconds.
EHome
-
You do not need to set the EHome protocol parameters.
*SIA-DCS or *ADM-CID
-
AX Security Control Panel User Manual
Figure 1-14 Alarm Receiving Center Parameters
21