Activate Via Sadp - HIKVISION AX DS-PW32-H Series User Manual

Steps
1. Run the client software.
2. Enter Device Management or Online Device.
3. Check the device status from the device list, and select an inactive device.
4. Click Activate.
5. Create and confirm the admin password of the device.
Caution
STRONG PASSWORD RECOMMENDED-We highly recommend you create a strong
password of your own choosing (using a minimum of 8 characters, including
upper case letters, lower case letters, numbers, and special characters) in order
to increase the security of your product. And we recommend you reset your
password regularly, especially in the high security system, resetting the password
monthly or weekly can better protect your product.
6. Click OK to start activation.
Device status will change to Active after successful activation.
7. Edit IP address of the device.
1) Select a device and click Modify Netinfo at Online Device.
2) Change the device IP address to the same subnet with your computer by
either modifying the IP address manually or checking DHCP.
3) Input the admin password of the device and click OK to complete
modification.

1.6.3 Activate via SADP

SADP is a tool to detect, activate and modify the IP address of the device over the
LAN.
Before You Start
Get the SADP software from the supplied disk or the official website http://
•
www.hikvision.com/en/ , and install the SADP according to the prompts.
The device and the PC that runs the SADP tool should be within the same
•
subnet.
The following steps show how to activate a device and modify its IP address. For
batch activation and IP addresses modification, refer to User Manual of SADP for
details.
AX Security Control Panel User Manual
14