Add Card - HIKVISION AX DS-PW32-H Series User Manual

Note
Select HAP-Device Serial No. as the hotspot and enter the hotspot password. By
default, the password is AP + Device Verification Code. The verification code is
normally printed on the device label.
5. Return to the mobile client and create a device password for device activation.
Note
We highly recommend you to create a strong password of your own choosing
(using a minimum of 8 characters, including at least three kinds of following
categories: upper case letters, lower case letters, numbers, and special
characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security
system, resetting the password monthly or weekly can better protect your
product.
6. Optional: If you add the control panel by entering its serial No., you should enter
the device verification code and tap OK.
Note
By default, the verification code is printed on the device label.
7. Follow the instructions and change the control panel to the Station mode. Tap
Next.
Note
You need to remove the rear panel of the device and the AP/STA switch is on the
back of the device.
8. When the control panel adding is completed, tap Finish.
The control panel is listed on the Hik-Connect page.

2.5.4 Add Card

You can add card to the control panel. Use the card to arm, disarm, or clear alarm.
Steps
1. Select a control panel on the Hik-Connect page to enter the control panel
management page.
AX Security Control Panel User Manual
69