Activate Device Via Ivms-4200 - HIKVISION AX DS-PW32-H Series User Manual

Use web browser to activate the device. Use SADP software or PC client to search
the online device to get the IP address of the device, and activate the device on the
web page.
Before You Start
Make sure your device and your PC connect to the same LAN.
Steps
1. Open a web browser and input the IP address of the device.
Note
If you connect the device with the PC directly, you need to change the IP address
of your PC to the same subnet as the device. The default IP address of the device
is 192.0.0.64.
2. Create and confirm the admin password.
Caution
STRONG PASSWORD RECOMMENDED-We highly recommend you create a strong
password of your own choosing (using a minimum of 8 characters, including
upper case letters, lower case letters, numbers, and special characters) in order
to increase the security of your product. And we recommend you reset your
password regularly, especially in the high security system, resetting the password
monthly or weekly can better protect your product.
3. Click OK to complete activation.
4. Edit IP address of the device.
1) Enter IP address modification page.
2) Change IP address.
3) Save the settings.

1.6.2 Activate Device via iVMS-4200

is a PC client to manage and operate your devices. Security control panel activation
is supported by the software.
Before You Start
Get the client software from the supplied disk or the official website http://
•
www.hikvision.com/en/ . Install the software by following the prompts.
The device and the PC that runs the software should be in the same subnet.
•
AX Security Control Panel User Manual
13