Suzuki DL1000 Service Manual page 153

• Install the camshaft journal holders, intake and exhaust.
• Fasten the camshaft journal holders evenly by tightening the
camshaft journal holder bolts sequentially and diagonally. (Try
to equalize the pressure by shifting the wrench in the above
manner, to fasten the shafts evenly.)
NOTE:
* Damage to head or camshaft journal holder thrust surfaces
may result if the camshaft journal holders are not drawn down
evenly.
* Each camshaft journal holder is identified with a cast-on letters
A.
• Tighten the camshaft journal holder bolts to the specified
torque.
$ Camshaft journal holder bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
#
The camshaft journal holder bolts are made of a spe-
cial material and much superior in strength, compared
with other types of high strength bolts.
Take special care not to use other types of bolts
instead of these special bolts. To identify these bolts,
each of them has a figure "9" on its head.
• Recheck the No.1 (Front) camshaft positions, intake and
exhaust.
"I"
IN
Engraved line
No.1 (Front) cylinder head
FRONT
ENGINE 3-107
"E"
Engraved line
EX