Suzuki DL1000 Service Manual page 114

3-68 ENGINE
• Remove the oil jet with a suitable bar.
• Remove the oil jet.
Check the oil jets for clogging. If they are clogged, clean their oil
passage with a proper wire or compressed air.
• Fit the new O-ring to the oil jet.
#
Use the new O-ring to prevent oil leakage.
NOTE:
Apply engine oil to the O-ring when installing the oil jet.
• Install the oil jet with a suitable bar.
• Tighten the oil gallery plug to the specified torque.
$ Oil gallery plug (M8): 18 N·m (1.8 kgf-m, 13.0 lb-ft)