Suzuki DL1000 Service Manual page 82

3-36 ENGINE
CAMSHAFT JOURNAL WEAR
Determine whether or not each journal is worn down to the limit
by measuring the oil clearance with the camshaft installed in
place. Use the plastigauge A to read the clearance at the widest
portion, which is specified as follows:
& Camshaft journal oil clearance
Service Limit (IN & EX): 0.150 mm (0.0059 in)
" 09900-22301: Plastigauge
09900-22302: Plastigauge
NOTE:
Install camshaft journal holder to their original positions.
Tighten the camshaft journal holder bolts evenly and diagonally
to the specified torque.
$ Camshaft journal holder bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
Do not rotate the camshaft with the plastigauge in place.
Remove the camshaft holders, and read the width of the com-
pressed plastigauge with envelope scale. This measurement
should be taken at the widest part.
If the camshaft journal oil clearance measured exceeds the limit,
measure the inside diameter of the camshaft journal holder and
outside diameter of the camshaft journal. Replace the camshaft
or the cylinder head depending upon which one exceeds the
specification.
& Camshaft journal holder I.D.
Standard (IN & EX):
22.012 – 22.025 mm (0.8666 – 0.8671 in)
" 09900-20602: Dial gauge (1/1000, 1 mm)
09900-22403: Small bore gauge (18 – 35 mm)
& Crankshaft journal O.D.
Standard (IN & EX):
21.972 – 21.993 mm (0.8650 – 0.8659 in)
" 09900-20205: Micrometer (0 – 25 mm)