Suzuki DL1000 Service Manual page 131

• Hold the generator rotor with the special tool.
" 09930-44541: Rotor holder
• While holding the generator rotor, tighten the cam drive idle
gear/sprocket nut to the specified torque.
$ Cam drive idle gear/sprocket nut:
#
Before tightening the cam drive idle gear/sprocket nut,
be sure to engage the front and rear cam chains to
each sprocket.
OIL SUMP FILTER
• Clean the oil sump filter using compressed air.
• Install the oil sump filter.
NOTE:
The projection A of the oil sump filter faces to the bottom.
GEAR POSITION SWITCH
• Install the springs 1 and gear position switch contacts 2.
70 N·m (7.0 kgf-m, 50.5 lb-ft)
ENGINE 3-85