Basic Settings - Physiomed Jubilee Operating Instructions Manual

Basic Settings

9 Basic Settings
In the basic settings, you can set different parameters that are rarely altered. Select
the button
SETMENU
Note The current software version is shown in the upper status bar.
The symbols have the following meaning:
To alter a parameter, proceed as follows:
(1) Choose
SETMENU
(2) Change to the second page (ultrasound) if required.
(3) Select the desired parameter with the data selector <5> and confirm.
(4) Set the desired value of the parameter. The modification will be confirmed visu-
ally and by an acoustic signal.
(5) Quit the basic setup.
The selected settings are immediately valid.
42
from the display <3> to get to the basic settings.
Screen contrast
Active menu when switching on the device
means that the start menu will appear.
START MENU
With
LAST CURRENT MODE
mode and its therapy parameters is displayed. Please
consider that a current mode is stored only after two
complete therapy cycles.
Biphase current: Either a break between two half waves
or two half waves immediately one after the other
Quit basic settings
on the display <3>.
the recently used current
PHYSIOMED-Jubilee