Table of Contents
Advertisement
2 Controls and Indicators
As its LCD is divided in different function fields,
and easy operation.
The plastic housing and the front panel protect the electronic components and sim-
plify cleaning.
Safety-related components are continuously monitored by the microprocessor, erro-
neously initiated operating steps are suppressed, a self-test routine is performed af-
ter switching on and possible malfunctions are displayed. For safety reasons, stimu-
lation current output is automatically cut off in case of malfunction.
2.1 Function of Controls and Indicators
In the following section we will introduce the individual controls of
. The numbers in angle brackets refer to the
Jubilee
ginning of this manual.
2.1.1 Mains Module <1>
Set the Line Voltage
After replacing the fuses, you can run the instrument with 230 V as well as 115 V
simply by using the rotatable fuse carrier at the mains module <1> (refer to section
Technical Data
module <1> in a fuse carrier.
Replace 1 A fuses with 2 A fuses, turn the fuse carrier by 180° and insert it again, so
that the "red window" of the mains module <1> reads "115 V", after the cover
has been closed again.
Warning Set the line voltage at the mains module to match the incoming line
voltage!
PHYSIOMED-Jubilee
The mains module <1> with mains supply, fuses and mains switch
is situated at the rear side of the instrument.
For mains supply do only use the mains cable provided by the
manufacturer.
is switched on and off using the integrated
PHYSIOMED-Jubilee
mains switch. After switching on, a self-test is automatically car-
ried out by the instrument (cf.
on page 56). The fuses are situated under the cover of the mains
PHYSIOMED-Jubilee
Instrument Overview
Notes on Operation
on page 26).
Controls and Indicators
allows for clear
PHYSIOMED-
at the be-
3
Advertisement
Table of Contents
