Table of Contents
Advertisement
FM6100 Series Multi-Point Lock
Installation of the Deadbolt Assembly
1
• Place the window shutter on a horizontal surface with the
pin lever notch located at the top of the shutter facing up.
• The recommended deadbolt assembly location should be
equidistant from the top and bottom of the shutter.
• Assemble the deadbolt case into the lock pocket
provided in the door. Note the orientation of the lock, the
top of the deadbolt case indicates that this should be
toward the top of the shutter.
• Assemble the lock to the edge of the shutter using
(2) 1/4 – 20 by 1" Flat Head Cap Screws.
Installation of the Bottom Bolt Assembly
2
• Loosen the set screw so that the lifting platform will slide
along the lower rod tubing but not slide on its own when
the rod is held vertically. Be sure that the set screw is
oriented so that it will be accessible through the Lower
Through Bolt Cutout on the top side of the shutter.
• When you insert the assembly into the shutter and
through the nylon guides of the deadbolt case this lifting
pad will be in a position to allow you to make the final
necessary adjustment.
Note the orientation of the bottom bolt assembly the
double screw head side (not shown in this image) should
be facing the hinge side of the shutter.
Continue on next page.............
Set Screw
A8058:A • www.sargentlock.com
Lower
Through
Bolt Cutout
3
Advertisement
Table of Contents
