Installation Instructions - Assa Abloy SARGENT 8200 Series Installation Instructions Manual

8200 Series Mortise Locks with Standard Levers
Motorized Electric Latch Retraction (56-)

Installation Instructions

3
How To Change Hand of Lock
Note: Red surface of locking piece must face secure (keyed/locked) side of
door.
To rotate locking piece:
1. Position lockbody with red surface of locking piece
visible.
2. Insert blade type screwdriver into locking piece slot to
rotate locking piece.
3. Push locking piece toward back of lock body and rotate
180° until RED surface shows on opposite side.
Note: Beveled surface of latch must face strike. The
deadlatch is self adjusting. To change hand of latch, see
step a. in the figure below.
a. Insert flat blade screwdriver
into the spade shaped slot.
Lock front
4. Rotate screwdriver 90º to push latch out until back of latch clears lock front.
5. Then rotate latch 180º. Latch will then re-enter lockbody.
Note: Latch can not be unscrewed.
4
Door Preparation & Install Lock
1. Confi rm the handing of the lock (latch and locking piece)
matches the handing of the door. Connect lock harness
to electrolynx cable routed through the door. Slide lock
into the door and hold.Verify strike location according to
template. Clean door pocket and verify hand of lock.
Important: Check template A7057 and A7065 to prep door
for function holes, size and location. Verify strike locations
according to templates. Clean out door pocket and door
edge of any debris.
2. Slide outside lever and rose assembly (or lever and
escutcheon assembly) through door and lockbody.
Important: Door must remain open during
installation. Use door stop.
1-800-810-9473 • www.sargentlock.com
Copyright © 2024, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or in part without the
express written permission of SARGENT Manufacturing Company is prohibited.
Latch
Locking piece slot
DOOR HANDING
INSIDE
LEFT HAND
OUTSIDE
INSIDE
LEFT HAND
REVERSE
BEVEL
OUTSIDE
DOOR HANDS DETERMINED FROM OUTSIDE
RH Door Shown
2
Red color indicates locked
side of door.
RIGHT HAND
RIGHT HAND
REVERSE
BEVEL
To view a video of this
step, download a free
mobile app and scan
the QR code with your
mobile device.
Outside of Door
Inside of Door
A8385-1 02/24