Rinsing; Hopper Cleaning; Disassembly - Taylor Wawa C708 Operator's Manual

OPERATING PROCEDURES

Rinsing

1. Pour 2-1/2 gal (9.5 L) of cool, clean water into the mix
hopper. Using the white hopper brush, scrub the mix
hopper, mix-level sensing probes and the outside of
the agitator driveshaft housing. With the 
double-ended brush, brush-clean the mix inlet hole.
(See Figure 6-45.)
Note: Do not brush-clean the mix inlet hole while the
machine is in the Wash mode.
2. With a pail beneath the door spout, open the draw
6
valve and press the Wash key
3. Drain all the rinse water from the door spout. Close
the draw valve and press the Wash key,
the Wash mode.
4. Repeat this procedure using clean, warm water until
the water being discharged is clear.
6-14
Figure 6-45
. (See Figure 6-46.)
Figure 6-46
canceling

Hopper Cleaning

1. Prepare a 2-1/2 gal. (9.5 L) pail of cleaning/sanitizing
solution with an active chlorine concentrate of 100 to
200 PPM (parts per million).
Important! Use warm water and follow the
manufacturer's specifications.
2. Pour the solution into the hopper and allow it to flow
into the freezing cylinder.
12029
3. Using the white hopper brush, clean the mix hopper,
mix-level sensing probes and outside of the agitator
driveshaft housing. Using the double-ended brush,
clean the mix inlet hole.
Note: Do not brush-clean the mix inlet hole while the
machine is in the Wash mode.
4. Press the Wash key
solution in the freezing cylinder to contact all areas of
the freezing cylinder. Allow the cleaning solution to
agitate in the freezing cylinder for 5 minutes.
5. Place an empty pail beneath the door spout.
6. Open the draw valve and draw off all the solution.
7. Once the cleaning solution stops flowing from the
door spout, close the draw valve and press the Wash
key , canceling the Wash mode.
13722

Disassembly

Note: Failure to remove the parts specified below for
brush-cleaning and lubrication will result in damage to
the machine. These parts must be removed within the
maximum number of days allowed between brush-clean
cycles or the machine will hard lock and display the
following message:
BRUSH CLEAN TIMEOUT
FREEZER LOCKED
CLEANING REQ'D
> BRUSH CLEAN
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
Model C708 - WAWA

. This causes the cleaning
Operating Procedures