Taylor Wawa C708 Operator's Manual page 31

(L/R) HPR>59F (15C)—The mix temperature in the
hopper exceeded 59°F (15°C).
(L/R) BRL>59F (15C)—The mix temperature in the
freezing cylinder (barrel) exceeded 59°F (15°C).
(L/R) TOO COLD—The mix temperature in the freezing
cylinder (barrel) has dropped below 10°F (-12°C).
Heat Cycle Summary
The HEAT CYCLE SUMMARY screen displays the hours
since the last Heat cycle, the hours since the product
temperature was above 150
of Heat cycles completed since the last brush-clean date.
HEAT CYCLE SUMMARY
H R S S N I C E H C
H R S S N I C E 1 5 0
H C S N I C E B C
Heat Cycle Data
The HEAT CYCLE DATA screen displays critical times
and temperatures for 366 Heat Treatment cycles.
Entering this option displays the first screen:
HEAT TREAT CYCLE
00/00 00:00
NO FAULT FOUND
When in a Heat cycle, a new record is created with the
current Heat cycle data. Upon completion of the current
Heat cycle, this data is permanently stored as record 1,
and all other data records are shifted back one. Record 1
contains the most recently completed Heat cycle.
Pressing the Up arrow key will cycle the data pages from
most recent to oldest. Pressing the Down arrow key
cycles from oldest to most recent.
User Interface
° °
F (65.6 C), and the number
0
0
0
00:00
1
Model C708 - WAWA
Line 2 displays the month and day the Heat cycle was
started, and the start and end times of the Heat cycle.
Line 3 displays the Heat cycle failure message if one
exists. If no faults were found during the Heat cycle, the
screen will display NO FAULT FOUND.
Line 4 displays the page number.
Pressing the Up arrow key displays a separate screen for
each side of the machine:
H: 42.0 B:
HEAT OVER
0:02 0:00 h
0:02 0:00 b
Line 1 displays the hopper and barrel temperatures
recorded when the Heat cycle terminated, normally or
abnormally. The two characters on this line indicate the
Heat cycle failure code, if a failure occurred.
Line 2 displays the heading for each time and
temperature.
Line 3 displays the time spent in the heat and cool
phases for the hopper and the peak hopper temperature
through the entire Heat cycle. It also displays the amount
of time that the hopper temperature was greater than the
Hold temperature.
Line 4 displays the time spent in the heat and cool
phases for the barrel, and the peak barrel temperature
through the entire Heat cycle. It also displays the amount
of time that the barrel temperature was greater than the
Hold temperature.
Pressing the SEL or MENU key returns the display to the
menu screen.
USER INTERFACE
25.0 PS
COOL PEAK
0:00 42.0
0:00 25.0
5-13
5