Draining Product From The Freezing Cylinder; Rinsing; Cleaning - Taylor Tim Hortons 390 Original Operating Instructions

Draining Product From The
Freezing Cylinder
Step 1
Place the power switch in the "OFF" position as far
ahead of cleaning time as possible to allow frozen
product to soften for easier cleaning.
Step 2
Remove the hopper cover and take it to the sink for

cleaning.

Step 3
With a sanitized pail beneath the door spout, place
the power switch in the "WASH" position and move
the draw handle to the right. When all the product
stops flowing from the door spout, move the draw
handle to the left and place the power switch in the
"OFF" position. If local health codes permit, empty
the product into the rerun can. Cover the container
and place it in the walk-in cooler.
FOLLOW YOUR LOCAL HEALTH CODES.

Rinsing

Step 1
Pour two gallons (7.6 liters) of cool, clean water into
the mix hopper. With the brushes provided, scrub
the mix hopper and mix inlet hole.
Figure 28
Step 2
With a pail beneath the door spout, place the power
switch in the "WASH" position and move the draw
handle to the right. Drain all the rinse water from the
Model 390 Tim Hortons
freezing cylinder. When the rinse water stops flowing
from the door spout, move the draw handle to the
left and place the control switch in the "OFF"
position.
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.
Cleaning
Step 1
Prepare an approved 100 PPM cleaning solution
(examples: 2-1/2 gal. [9.5 liters] of Kay-5
gal. [7.6 liters] of Stera-Sheen ). USE WARM
WATER AND FOLLOW THE MANUFACTURER'S
SPECIFICATIONS.
Step 2
Pour the cleaning solution into the hopper and allow
it to flow into the freezing cylinder.
Step 3
While the solution is flowing into the freezing
cylinder, brush-clean the mix hopper and mix inlet
hole.
Step 4
Place the power switch in the "WASH" position. This
will cause the cleaning solution in the freezing
cylinder to be agitated.
Step 5
Place an empty pail beneath the door spout and
move the draw handle to the right. Draw off all the
cleaning solution. When the solution stops flowing
from the door spout, move the draw handle to the
left, and place the power switch in the "OFF"
position.
19
or 2
Figure 29
Operating Procedures