Taylor Wawa C708 Operator's Manual page 55

Problem
13. Excessive mix leakage
into the long drip pan.
14. The driveshaft is stuck
in the drive coupling.
15. The freezing cylinder
walls are scored.
16. The product makes a
popping sound when
drawn.
Troubleshooting Guide
Probable Cause
a. The seal on driveshaft is
improperly lubricated or worn.
b. The seal is installed inside out on
the driveshaft.
c. Inadequate lubrication of the
driveshaft.
d. The driveshaft and beater
assembly worked forward.
e. Worn rear shell bearing.
f. Gearbox out of alignment.
a. Mix and lubricant collected in the
drive coupling.
b. Rounded corners of driveshaft, the
drive coupling, or both.
c. Gearbox is out of alignment.
a. Missing or worn front bearing and
beater shoes.
b. Scraper blades are damaged.
c. Machine was placed in Auto mode
before all sanitizing solution was
removed from freezing cylinder.
d. Broken freezer door baffle rod.
e. Broken beater pins.
f. Beater assembly is bent.
g. Gearbox is out of alignment.
a. Draw rate is set too fast.
b. Pump assembled incorrectly.
c. Freezing cylinder not primed
correctly.
Model C708 - WAWA
TROUBLESHOOTING GUIDE
Remedy
a. Lubricate properly or replace the seal.
b. Install correctly.
c. Lubricate properly.
d. Call a service technician.
e. Call a service technician.
f. Call a service technician.
a. Brush-clean the rear shell bearing
area regularly.
b. Call a service technician.
c. Call a service technician.
a. Install or replace the front bearing and
beater shoes.
b. Replace scraper blades.
c. Place machine in Auto mode only
after priming is complete and all
sanitizing solution is removed.
d. Replace freezer door.
e. Replace beater assembly.
f. Replace beater assembly.
g. Call a service technician.
a. Adjust draw rate of 5 oz. to 7-1/2 oz.
(142 g to 213 g) of product by weight
in 10 seconds.
b. Assemble and lubricate according to
instructions in this manual.
c. Drain the freezing cylinder and
reprime the machine.
Page
Ref.
6-1
6-1
6-1
- - -
- - -
- - -
6-16
- - -
- - -
6-3
6-2
6-14/6-11
- - -
6-5
6-5
- - -
5-3
6-6
6-10
8
8-3