Taylor Wawa C708 Operator's Manual page 37

8. If the blades are in good condition, place the rear
scraper blade over the rear holding pin on the beater.
To prevent costly damage, make sure the hole on the
scraper blade fits securely over the pin. (See
Figure 6-8.)
Figure 6-8
Note: Scraper blades should be replaced every 3
months.
9. Holding the rear blade on the beater, slide it into the
freezing cylinder halfway. Install the front scraper
blade over the front holding pin. (See Figure 6-9.)
Figure 6-9
10. Before installing the beater shoes, check the shoes
for any nicks, cracks, or signs of wear. If any defects
are present, replace the beater shoes.
Operating Procedures
11. If the beater shoes are in good condition, install the
beater shoes. (See Figure 6-10.)
11534
12. Slide the beater assembly the rest of the way into the
freezing cylinder.
Make sure the beater assembly is in position over the
driveshaft by turning the beater slightly until the
beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder. (See Figure 6-11.)
11531
Model C708 - WAWA
OPERATING PROCEDURES
Figure 6-10
Figure 6-11
11532
11533
6
6-3