Taylor Wawa C708 Operator's Manual page 29

Agitator Operation
The AGITATOR OPERATION option allows the manager
to select either continuous or intermittent agitator
operation.
The Agitator may be set to operate in the standard mode
or "with Hopper Refrig." In the standard mode, the
agitator operates during Auto, Standby, and Heat
Treatment. In the "with Hopper Refrig" mode, it runs only
when the hopper is refrigerating and during the heat,
hold, and soak phases of a Heat cycle, and the cool
phase of a Heat cycle if the hopper is refrigerating. The
default is "Standard operation."
AGITATOR OPERATION
> Standard operation
with Hopper Refrig
Exit
Use the arrow keys to move to the desired operation and
press the SEL key to accept the selection.
Mix Level Audible
The MIX LEVEL AUDIBLE option, when enabled, alerts
the operator with an audible tone when there is Mix Low
or Mix Out condition. The following screen is displayed:
MIX LEVEL AUDIBLE
ENABLED
> Enable
Disable
Disable the audible tone feature by pressing the Down
arrow key to move the arrow to "Disable." Press the SEL
key to save the new setting and return to the menu. The
control panel icons for Mix Low and Mix Out will
illuminate as the mix level drops in the hopper, but the
audible tone will be disabled.
User Interface
Fault Description
The FAULT DESCRIPTION screen indicates a fault with
the freezer and where the fault occurred. When no faults
are detected, the following screen will be displayed:
FAULT DESCRIPTION
NO FAULT FOUND
Press the SEL key to display the next fault found, or
return to the Manager's Menu if no other faults exist.
Pressing the SEL key anytime faults are displayed will
clear the faults, if corrected, upon returning to the menu
screen.
Listed below are the variable messages which will
appear, along with an explanation for the corrective
action.
NO FAULT FOUND—There was no fault found in the
freezer. Nothing will appear on the screen after this
variable message appears.
BEATER OVERLOAD—Place the power switch in the
OFF position. Wait 5 minutes for the machine to cool.
Press the beater reset button firmly. Place the power
switch in the ON position and restart in Auto mode.
COMPRESSOR HPCO—Place the power switch in the
OFF position. Wait 5 minutes for the machine to cool.
Place the power switch in the ON position and restart in
Auto mode.
HOPPER THERMISTOR FAIL*—Place the power switch
in the OFF position. Call a Taylor service technician.
BARREL THERMISTOR FAIL*—Place the power switch
in the OFF position. Call a Taylor service technician.
*Note: Three codes have been set up to assist in
diagnosing bad thermistor probes. If a probe has shorted,
SHRT will display for its respective machine location. If
the probe is open, OPEN will display. If the actual probe
environment exceeds 200°F (93°C), the respective
screen display location will display OVER, indicating the
temperature is out of range.
COMP ON TOO LONG—The compressor run time
exceeded the 11-minute timer. Replace the scraper
blades during the next brush-cleaning. If that doesn't
resolve the fault, call a Taylor service technician.
Model C708 - WAWA
USER INTERFACE
5-11
5