Festo CPX DE Series Manual page 45

1. Overview and sub−bases for CPX I/O modules
Festo P.BE−CPX−EA−EN en 0804g
Fitting the sub−bases:
1. Only CPX−M−8−M12x2−5POL:
Observe the following asymmetrically arranged features
for the correct alignment of the components:
the centre electrical plug connector and
the optical wave guide for the error LED.
2. Align the sub−base over the manifold sub−base with the
electronic module. Make sure that the plug connectors of
the sub−base are aligned exactly with the connectors of
the electronic module. Then push the sub−base carefully
and without tilting onto the manifold sub−base.
3. Tighten the screws at first only by hand. Place the screws
so that the self−cutting threads can be used.
Tighten the screws with a TORX screwdriver size T10 with
torque 0.9 1.1 Nm.
1−27