Festo CPX DE Series Manual page 43

1. Overview and sub−bases for CPX I/O modules
Dismantling
1
Sub−base
2
Screws
3
Electrical plug
connector
4
Electronics
module
5
Contact rails
6
Manifold base
Fig. 1/8: Fitting/removing the I/O module (representation)
Festo P.BE−CPX−EA−EN en 0804g
Dismantle the sub−base as follows (see Fig. 1/8):
1. Loosen the 4 screws in the relevant sub−base with a TORX
screwdriver size T10.
2. Pull the sub−base carefully and without tilting away from
the electrical plug connection of the electronic module.
Only in cases where the electronic module is to be removed:
Pull the electronic module carefully and without tilting
·
away from the contact rails of the manifold sub−base.
1
3
2
4
5
6
1−25