Troubleshooting - Husqvarna P 524XR EFI Operator's Manual

Note:
The battery time can decrease in cold weather.
Before operation, the battery must be connected to a
battery charger. It is necessary to charge the battery
before you use the remote control for the first time.
Note:
Put the remote control to off when it is not in
operation to save battery. The remote control does not
automatically come off when it is not in operation.
To remove and install the remote control
battery in the remote control
1. Turn the remote control to get access to the rear
side where the battery is.
2. Remove or install the remote control battery.
To charge the remote control battery with the
battery charger
The charging time for an empty remote control battery
is approximately 2 hours with the battery charger. When
you charge the remote control battery, the temperature
must be between 0°C and +45°C.
1. Remove the empty remote control battery from the
remote control. Refer to
remote control battery in the remote control on page
70 .

Troubleshooting

For instructions for the remote control, refer to
control on page 74 .
70
To remove and install the
Troubleshooting
Remote
2. Connect the battery charger to a power outlet. The
power indicator (A) for the battery becomes red.
Status of the battery charger on page 79 .
Refer to
3. Connect the remote control battery to the battery
charger. Make sure that the arrows (B) on the
remote control battery and the battery charger align.
The indicator (C) for the battery status on the battery
charger flashes green when the remote control
battery charges.
4. When the remote control battery is fully charged,
the indicator becomes green. Remove the remote
control battery from the battery charger.
5. Disconnect the battery charger from the mains
outlet.
If you cannot find a solution to your problems in this
manual, speak to your Husqvarna servicing dealer.
B
A
C
1929 - 003 - 05.12.2023