Changing Link Stay - Husqvarna P 520D Workshop Manual

Chassis
Assembling
1. Clean and lubricate with grease before
assembling new bushings.
2. Hold the lift arm (6) in place and fit the threaded
bolt (3) and washers (4), (7), and nylon spacer (5).
3. Fit the shaft (1) with washers (9), (10).
4. Tighten first according to the table.
5. Then loosen the threaded bolt (3) until the nut
(8) starts to rotate.
6. Assemble remaining parts in the reverse order.
7. Lubricate the rear bushing through the grease
nipple and oil the front bushing.
6
5
1 2
3 4
1. Shaft with lug and grease nipple.
2. Screw
3. Threaded bolt
4. Washer
5. Nylon spacer
6. Lifting arm
14
– English
8
7
9
10 11
1
7. Washer
8. Nut
9. Washer
10. Washer
11. Circlip

Changing Link Stay

Tools Dimension
Torx
Combination 15 mm
wrench
Combination 17 mm
wrench
Socket wrench 15 mm
Socket wrench 17 mm
Breaking bars
Torque wrench
Ring end for 17 mm
torque wrench
1. Apply park brake.
2. Remove the cover over the rear transmission.
3. Place a jack assembly as illustrated and
stabilize the mower, so that it does not fall when
the link stay is dismantled.
1
1. Area for jack assembly
Quantity
T30 1
1
1
1
1
1
1
1