SWF Dual Function E Series User Manual page 64

⑦ Applique
If you input needle bar repeat when setting the needle bar, and if the Applique function is set YES, the machine
will not trim but automatically stop when it comes to the needle bar to be overlapped.
- Basic setting is YES.
⑧ Auto Back Stitch
It sets the number of automatic backstitches to be made when thread break is detected.
- Basic setting is 2 stitches and you can set within the range of 0-5 stitches in the unit of 1 stitch.
⑨ Auto Start After Trimming
It sets whether to automatically start the next embroidery after trimming by jump code, trimming code, or stop
code.
- Basic setting is YES. If you do not want the automatic start, press "0" for NO.
⑩ Auto Start After Frame Back
In the case where embroidery should begin after the frame is moved back from the stop point, it sets whether to
automatically start the next embroidery when it reaches the point as described in ⑫ All Head Sewing Start Point
after F, B.
- Basic setting is YES. To cancel the function, press "0" for NO.
⑪ All Head Sewing After Stitch Back
※ The menu is not available for 1×1 Machine Type.
Move the frame backward from the machine stop point, and decide whether the head with broken thread only will
operate or whether all heads will operate when embroidery work is activated by the bar switch.
- Default is "single head." To operate all heads, enter "0" to select "All."
⑫ All Head Sewing Start Point After F,B
※ The menu is not available for 1×1 Machine Type.
When all or many needle bars are operating simultaneously, problem in one needle bar might be notified later (i.e.
thread break). In this case, when the machine is stopped, back-stitch can be conducted to correct the part where
5 5 - - 3 3 2 2