SWF Dual Function E Series User Manual page 63

① Total Stitch Clear
Total ST in '4.2.2 Machine Information' shows the number of stitches accumulated since the first use or
initialization of the machine. Initializing Total Stitches will initialize this information.
② Total Work Clear
Total WK in '4.2.2 Machine Information' shows the number of plates accumulated since the first use or
initialization of the machine information. Initializing Total Work Plates will initialize this information.
(To initialize, select "0" and press
③ Auto Origin Return
It brings the frame back to the start position after completing a design.
- Basic setting is "YES (1)". To cancel this function, press NO (0) for No.
④ Jump Change Data
It sets the width of stitch that changes an ordinary code to a jump code.
- In other words, the machine will automatically change to a jump code if the frame finds the distance between
two stitches is longer than the pre-set value. Basic setting is 8.0mm and you can set within the range of 5.0-
12.7mm in the unit of 0.1mm.
⑤ Auto Backtack
It sets whether or not to use the back-tack function (making stitches at the start of embroidery) for prevention of
thread unraveling.
- Default is 'End Backtack' and you can select in the range of No (0), Start Backtack (1), End Backtack (2), and
All (3).
⑥ Jump Convert (Length)
If the total length of stitches of the repeated Jump Code exceeds the set value, it performs trimming first, and
then sets the maximum jump stitch value for the next work.
- Default is 'NO' and you can select within the range of 1-50mm in the unit of 1mm.
. To cancel initialization, press
5 5 - - 3 3 1 1
.)