5.13.3 Machine test
It tests the machine by part to check if the machine is in normal condition.
[Fig.5.13.3-1] shows selection of Machine Test in [Fig.5.13.0-1].
•JUMP TEST : Checks the motion of the jump motor.
•WIPER TEST : It tests the wiper motor
•PICKER TEST : It tests the picker solenoid
•TRIM TEST : It tests the trimmer solenoid
•HOLDING TEST : This is used to check whether the main-shaft holding solenoid and the holding solenoid
attached to each head are moving properly.
•THREAD SENSING TEST : It tests the upper thread detecting sensor
•SEQUIN MOTION : Checks sequin motion (optional).
•SEQUIN LIFT UP/DOWN : Checks sequin device motion (optional).
5 5 - - 1 1 0 0 4 4
[Fig.5.13.3-1]
Need help?
Do you have a question about the Dual Function E Series and is the answer not in the manual?