Rj-45 And Aui Ports - HP -UX 11i Installation And Update Manual

Configuring Built-In PCI Networking

RJ-45 and AUI Ports

RJ-45 and AUI Ports
The 10/100 Base-TX link works with both an RJ-45 and (on the V-class)
an AUI port. The RJ-45 port can be used for either 100 Base-T or 10
Base-T networking; the AUI port is used only for 10 Base-T. Only one of
these ports should be connected to a network at any given time. The link
will normally attempt to automatically sense which port is connected
and configure that port, unless this is overridden via the Boot Time LAN
configuration described above.
If the RJ45 port is not connected to the network, the system will
configure itself to use the AUI port during boot-up or reset.
140 Appendix C