HP -UX 11i Installation And Update Manual page 44

TIP
NOTE
Step 10. When finished configuring your installation:
Step 11. When prompted, replace HP-UX 11i CD1 with the requested CD from
Step 12. The system automatically reboots after all software has been loaded.
Migrating to HP-UX 11i
Cold-installing HP-UX 11i
in Appendix B.
If you're installing an Ignite-UX server, be sure to select the entire
Ignite-UX server product, B5725AA, thus installing the new
make_tape_recovery(1M) command on your Ignite-UX server.
• At the end of the
review any messages that Ignite-UX encountered. If there are any
errors, resolve them before continuing with the installation.
Ignore any message stating that /var needs to be larger than available
to hold a dump file. /var typically only needs to be set to 50-100% as
large as the current memory to handle dump files.
• With
Guided Installation
• With
Advanced Installation
confirmation screen lists the disks that will be written to during
installation and a log of any warnings or errors encountered. You
have the chance to
previous configuration screen.
After you selecting
Finish
and loads a minimum set of commands and libraries. SD then downloads
all the products and patches from the first CD.
the media box. Software will be automatically loaded from each CD. If
you see the message:
Unable to verify CD-ROM media content ...
You may have pressed
displayed Recovery Action 1:
44
session, a screen allows you to
Guided Installation
, select:
Finish
, select
GO!
at this time. If you cancel, you return to the
Cancel
or , the system configures the hard disk(s)
GO!
before changing the CD. If so, select the
Enter
Retry software Load...
(at the bottom of any tab). A
and press
Enter
again.
Chapter 2