HP -UX 11i Installation And Update Manual page 120

Step 9. Go back to the regular init state: init 3 or init 4, or reboot.
Step 10. Wait 10 minutes after changing the system state or rebooting to let
Increasing /stand
Step 1. As root, use sam to create a new contiguous /swap volume of the
Step 2. Using sam, verify that there is no bad block relocation and the new
Step 3. As root from a console window, remove and add primary swap and dump
Step 4. Verify your change by entering:
In Case of Trouble
Adjusting File System Sizes
/sbin/mount /var
processes complete before your enter an update-ux command.
In some cases, you will need to increase the size of /stand prior to
completing a successful update to HP-UX 11i. If the update-ux command
fails with a message indicating that /stand is too small, follow these
steps to increase the size of /stand.
To increase /stand, you'll first have to create a larger /swap volume,
since both require contiguous blocks and are adjacent volumes. If you
need help with this procedure, refer to the Managing Systems and
Workgroups manual, available on the HP-UX 11i Instant Information CD
and on the Web:
docs.hp.com/hpux/onlinedocs/B2355-90701/B2355-90701.html
required size, say, 300 MB. Name the new volume /dev/vg00/swap.
/swap volume is contiguous.
devices:
1. Remove the current dump device:
lvrmboot -v -d lvol2 /dev/vg00
2. Add a new dump device:
lvlnboot -d /dev/vg00/swap
3. Remove the current swap device:
lvrmboot -s /dev/vg00
4. Add a new swap device:
lvlnboot -s /dev/vg00/swap
lvlnboot -v
120 Appendix B